Castle X Series Drivers Ed Guide
29 30
. Keep holding the trigger, within – seconds there will be sequence of four “rings” nd
the yellow LED will blink. You re now in progrmming mode; let the trigger return to neutrl.
To Make Changes In Programming Mode:
Once in progrmming mode, the ESC will beep once, puse, then beep once gin nd repet
until chnge is mde with your trnsmitter. For instnce, if you wnt to djust setting
(Brke/Reverse Type) to option (ith Reverse) you would pull full throttle to select it. hen
the trigger is returned to neutrl the beep pttern will chnge to beeps followed by beep.
By selecting n option, you hve now moved on to setting nd option . If t setting (Cutoff
Voltge) you reject option (Auto-LiPo) by going to full brke/reverse, the beep pttern will
then chnge to beeps followed by beeps. This mens the ESC is still t setting but is now
sking if you would like to ccept option (one).
Reject options unless you wish to chnge tht specific setting. As n exmple, sy you wnt to
djust the Drg Brke to %. ork through the settings nd options, rejecting ll options until
you get to beeps, mening setting (Drg Brke), followed by beeps, mening option
(%). Select this option by going to full throttle. Once you hve chnged the setting you wnt,
you cn unplug power from the ESC to get out of progrmming mode. You do not need to finish
ll of the settings. The ESC will store your chnges until you chnge them gin.
The next section of the mnul gives description of ech of the settings nd options nd
wht to expect when you chnge n option from defult.
There is reference guide on the lst pge of this mnul.