Mamba Micro X2 Quick Start Guide

MAMBA MICRO X2 SPECIFICATIONS
Application
Guidelines
1:18th: vehicles weighing up to 2.25lbs
1:14th: vehicles weighing up to 3lbs
Crawling: low speed crawling up to 9lbs
Input Voltage
Range
Min: 2S LiPo, Max: 4S LiPo, 16.8V
BEC
Specifications
Adjustable: 5.5V or 7.5V (2A Peak), default 5.5V
Waterproof Yes*
Sensors
Yes, with Sensor Harness (P/N 011-0108-00). Included with 1:14/
Crawler edition, sold separately with 1:18th edition.
Product Use
Statement**
• Applying voltages higher than 16.8V will cause irreparable damage to
your controller, voiding the warranty.
• Recommended battery capacity for 1:18th scale vehicles is 1500mAh.
30C continuous discharge. For 1:14th scale vehicles and crawler,
≥2,000mAh, 30c is recommended.
• The Mamba Micro X2 1:18th edition uses 3.5mm motor bullets; the
1:14th/crawler edition uses 4mm on the motor wires and the battery
input wires are bare. You must add the connector of your choice to
the battery leads. We recommend a high current connector rated for
at least 40 amps.
• Do not use 4s LiHV
RECEIVER CONNECTION
RX Wire Plug the RX wire into the throttle (#2) channel on your receiver.
AUX Wire
The AUX wire allows you to adjust a setting “on-the-fly” using an
auxiliary channel on your receiver. The AUX wire function is disabled
by default and is programmable via Castle Link. Plug this wire into the
auxiliary (#3/#4) channel on your receiver.
Contact
Castle Creations
540 North Rogers Road
Olathe, KS 66062
Support: www.castlecreations.com/contact-support
Sales: www.castlecreations.com/contact-service
Website: www.castlecreations.com/mambamicrox
TRANSMITTER PROGRAMMING REFERENCE
AUDIBLE ALERT REFERENCE
• •
Start Fail
• –
Low Voltage Cutoff
– •
Over-Current
• • •
Sensors Lost
• • –
Radio Glitch
• – •
Over-Temperature
• – –
Excessive Load
– • •
AUX Wire Radio Glitch
– – •
Motor Over-Temperature
1.Brake/Reverse Type 3. Brake Amount 5. Motor Type
•
With Reverse*
•
25%
•
Brushless*
• •
Without Reverse
• •
50%*
• •
Brushed Reversing
• • •
Crawler Reverse
• • •
75%
• • • •
100% 6. Motor Direction
2.Voltage Cutoff
•
Normal*
•
Auto-Lipo* 4. Drag Brake
• •
Reverse
• •
None
•
Disabled*
• •
10%
• • •
20%
• • • •
30%
• • • • •
Crawler Full On *Default Setting
*Not intended for operation while submerged in liquid. If unit is operated in wet conditions, rinse with fresh
water to remove dirt or corrosives, then fully dry unit.
**Failure to adhere to the Product Use Statement constitutes a violation of the warranty agreement, and will
result in non-warranty service fees to repair or replace damaged products.