MSDS

3.
Composition/information on ingredients
Ingredient name
CAS #
%
Base oil - highly refined
Varies
80 - 85
Long chain alkylamino thiophosphate
Proprietary
1 - 5
4.
First aid measures
Eye contact
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical
attention.
Skin contact
Immediately wash exposed skin with soap and water. Remove contaminated clothing and shoes.
Wash clothing before reuse. Clean shoes thoroughly before reuse. In the event of any complaints
or symptoms, avoid further exposure. Get medical attention.
Inhalation
If inhaled, remove to fresh air. Get medical attention if symptoms occur.
Ingestion
Do not induce vomiting unless directed to do so by medical personnel. Never give anything by
mouth to an unconscious person. If potentially dangerous quantities of this material have been
swallowed, call a physician immediately. Get medical attention if symptoms occur.
5.
Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire.
No action shall be taken involving any personal risk or without suitable training.
Protective clothing (fire)
Fire-fighters should wear appropriate protective equipment and self-contained breathing apparatus
(SCBA) with a full face-piece operated in positive pressure mode.
Fire-fighting procedures
Hazardous combustion
products
Combustion products may include the following:
carbon oxides (CO, CO
2
) (carbon monoxide, carbon dioxide)
nitrogen oxides (NO, NO
2
etc.)
In a fire or if heated, a pressure increase will occur and the container may burst.
Fire/explosion hazards
Flash point
Open cup: 180°C (356°F) [Cleveland.]
Extinguishing media
Suitable
Use an extinguishing agent suitable for the surrounding fire.
Do not use water jet.
Not suitable
6.
Accidental release measures
No action shall be taken involving any personal risk or without suitable training. Keep unnecessary
and unprotected personnel from entering. Do not touch or walk through spilled material. In
accordance with good industrial hygiene and safety work practices, airborne exposures should be
controlled to the lowest extent practicable. Provide adequate ventilation. Wear appropriate
respirator when ventilation is inadequate. Put on appropriate personal protective equipment (see
Section 8).
Stop leak if without risk. Move containers from spill area. Approach release from upwind. Prevent
entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent
treatment plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for
disposal according to local regulations (see section 13). Dispose of via a licensed waste disposal
contractor. Contaminated absorbent material may pose the same hazard as the spilled product.
Note: see section 1 for emergency contact information and section 13 for waste disposal.
Environmental
precautions
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers.
Inform the relevant authorities if the product has caused environmental pollution (sewers,
waterways, soil or air).
Personal precautions
Large spill
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up if water-
soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and place in an
appropriate waste disposal container. Dispose of via a licensed waste disposal contractor.
Small spill
Methods for cleaning up
Date of issue
04/15/2011.
Page: 2/6
Castrol Import Multi-Vehicle ATF
ENGLISH
(ENGLISH)
Product name
Product code
Version
2
Format
Language
US
465368-US12 US31
(US)