Use and Care Guide

16
Generator - Inspect
Once a month start the engine and run the
engine until it reaches normal operating
temperature (about 20 minutes). Plug in a
corded device and turn on the device to ensure
that the generator is providing power. Once you
have verified that the generator is providing
power, turn off the device and unplug it. Then
turn the generator off.
Spark Arrestor -
Inspect/Clean/Replace
This unit has a spark arrestor fitted to the
exhaust outlet of the muffler. The spark arrestor
should be cleaned with a soft wire brush after
every 50 hours or 3 months of use. The spark
arrestor should be replaced after every 100
hours of operation or if it becomes damaged.
Hot Surface
Hot parts or hot components can cause burns or
personal injury. Do not allow hot parts or
components to contact your skin. Use protective
clothing or protective equipment to protect your
skin.
DO NOT perform this maintenance procedure
until the muffler has cooled.
Remove screws (2). Remove spark arrestor (1)
Check the spark arrestor. Carefully clean the
spark arrestor with a soft wire brush. If the spark
arrestor is damaged, replace the spark arrestor.
To install the spark arrestor, align the mounting
holes in the spark arrestor with the mounting
holes on the muffler. Insert screws (2) and
tighten securely.
Spark Plug – Inspect/Adjust/Replace
Refer to the Specifications section of this
manual to determine the proper spark plug part
number and spark plug gap for your product.
1. Remove the side panel.
2. Remove the spark plug cap (3).
3. Use the plug wrench (1) to remove the
spark plug.
4. Visually check the spark plug to see if
it is damaged. If the insulator is
cracked, replace the spark plug. If the
electrode is damaged, replace the spark
plug.
5. Measure the plug gap (4) with a feeler
gauge. Adjust the gap as necessary by
carefully bending the side electrode.
Refer to Specifications for the correct
gap for your product.
6. Check the spark plug washer to ensure
proper working condition. If the washer
is damaged, replace the washer.
7. Install spark plug and tighten to 16 ± 2
lb ft (22 ± 2 Nm). DO NOT overtighten
as this may damage the engine.
Walk-Around Inspection
Before starting the engine perform a visual
inspection of the unit. Look for:
• Proper oil level
• Proper fuel level
• Good quality fuel
• Fluid leaks
• Loose clamps
• Loose bolts
• Cracked fuel line
• Loose or frayed wiring
• Built up debris
In addition, make sure that:
• The ground terminal is properly
connected
• The circuit breakers are in OFF “ 0 ”
position
1
2
3
4
1
2