How to Guide

Cat
®
RP12000 E Quick Reference Guide
What’s in the box?
Assembling the unit
Starting the unit (Please register your product for warranty before starting.)
Stopping the unit
Control
panel
layout
Troubleshooting
WARNING: This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product.
Using the generator
1. Make sure the generator can supply enough running and starting watts for the items you will power at
the same time.
2. Start the generator with nothing connected.
3. Plug in and turn on the rst load, preferably the largest load you have.
4. Permit the generator output to stabilize (engine runs smoothly and attached device operates properly).
5. Plug in and turn on the next load.
6. Again, permit the generator to stabilize.
7. Repeat previous two steps for each additional load. IMPORTANT: Never add more loads than
the generator capacity. Take special care to consider surge loads in generator capacity.
8. NOTE: Turn the generator switch to the off “0”position when not in use to avoid battery drain.
Add oil.
Remove both 8 mm bolts from
the pallet and frame. Remove
both wood blocks.
Remove all devices
connected to the unit.
Rotate the fuel valve to
the OPEN position.
Once the engine is
warm, slowly push the
choke knob in.
Rotate the start switch
to RUN.
Turn circuit breaker to
the On “1” Position.
Assemble the lifting
eye.Torque bolts to
26 lb-ft (35 N-m).
Connect the
battery (negative).
Assemble the
handle.
Add Oil using funnel. Add Oil to this level.
Complete the rotation
to START.
Add fuel.
Rotate the start switch
to the OFF position. (Note 8)
If the engine is cold, pull
the choke knob out before
starting the engine.
Close the fuel valve.
Start Switch: OFF-----RUN-----START
Choke
Do not connect to a building’s electrical system
unless the generator and transfer switch have
been properly installed and the electrical output
has been veried by a qualied electrician. The
connection must isolate the generator power from
utility power and must comply with all applicable
laws and electrical codes.
QR code and contact info
For more information regarding this product, contact 844.797.6387
or [e-mail].
For more information, including setup and usage videos.
USA: cat.com/homeandoutdoorpower
CAN: cat.com/homeandoutdoorpower-CA
WARNING
Item No. Description Qty.
Tools
1 13/15 mm wrench 2
2 14/17 mm wrench 2
3 Spark plug wrench 1
4 Screwdriver 1
Servicing Items
1 32 . oz. (946 ml) of oil 2
2 Oil funnel 1
All fixtures and fittings are supplied in the box, as well as the above items.
Please register your generator for warranty before starting.
Missing parts or accessories or need assistance with this unit?
USA: cat.com/homeandoutdoorpower-support
CAN: cat.com/homeandoutdoorpower-support-CA
844.797.6387
Register your product for warranty
Connect your devices.
(See “Using the generator”
for more information)
8
85
9
2
2
6
3
3
41
START
1
STOP
1
Install the feet.
2
Install the wheels.
3
65 7
7
© 2017 Caterpillar. All Rights Reserved. CAT, CATERPILLAR, their
respective logos, “Caterpillar Yellow,” the “Power Edge” trade
dress, as well as corporate and product identity used herein, are
trademarks of Caterpillar and may not be used without permission.
LEHQ0054-00
8
4
Issue Possible Cause Solution Check
Engine Will Not Start
Generator switch in the off
“ 0 ” position
Turn the generator switch to
the correct position.
Start the engine.
Choke knob in the wrong
position
Place the choke knob in the
correct position.
No fuel Fill the fuel tank.
Bad or contaminated fuel Check the fuel.
Not enough oil in the engine
Check the oil level. If low,
add the recommended oil.
Dirty air lter Clean the air lter.
No fuel at the carburetor
Make sure the fuel switch is
in the on “ I “ position.
Engine ooded Wait 5 minutes.
No spark Replace the spark plug.
No battery power
Check the battery. If the
battery is providing less
than 12.7 volts, charge the
battery, if providing less
than 12.4 volts, replace the
battery.
If the engine still will not
start:
Take the unit to an authorized service provider.
Engine Runs Rough (no load)
Dirty air lter
Stop the engine and check
the air lter. Clean if needed.
Start the engine / check if it
runs rough
Choke knob in the wrong
position
Place the choke knob in the
correct position.
If the engine still runs rough: Take the unit to an authorized service provider.
Engine Shuts Down
Out of fuel
Check the fuel. Fill the tank
if necessary.
Start the engine / check if it
shuts down.
Not enough oil in the engine
Check the oil level. If low,
add the recommended oil.
Dirty air lter Clean the air lter.
Generator overloaded Unplug some of the devices.
If the engine still shuts
down:
Take the unit to an authorized service provider.
Engine Runs Rough (with
load)
Dirty air lter
Stop the engine and check
the air lter. Clean if needed.
Start the engine / check if it
runs rough.Generator overloaded Unplug some of the devices.
Defective device plugged in Unplug defective device.
If the engine still runs rough: Take the unit to an authorized service provider.
Engine Runs, But Generator
Does Not Provide Power
Circuit breaker is open Close the circuit breaker.
Start the engine / check for
power.
Bad connection
Stop the engine and check
the connections.
Defective power cord Replace the cord.
Defective device plugged in Unplug defective device.
If there is still no power: Take the unit to an authorized service provider.
USA CAN
USA
CAN