Operating Guide

7
ASSEMBLY
NOTE: Only assemble unit with the included
hardware to avoid the risk of personal and
property damage.
Unpackaging
1. Remove both 8 mm bolts (1) from the
pallet and frame.
2. Remove both wood blocks (2) from
below the engine and alternator.
Feet Assembly
1. Set the frame of the unit on blocks to
provide sufficient clearance to install the
feet and wheels.
2. Align the foot (4) with the mounting hole
in the foot bracket (1).
3. Install and hand tighten one 8 mm nut
(2) onto the foot.
4. Tighten the nut securely.
5. Align the mounting holes of the foot
bracket (1) with the mounting holes in
the frame.
6. Insert one 8 mm bolt (3) through each
set of mounting holes and hand tighten.
7. Repeat steps 2 – 6 for the other foot.
8. Tighten all eight bolts securely.
Wheel Assembly
1. Insert long end of axle (5) into the
mounting bracket on the frame and run
through to insert into the other mounting
bracket on opposite side of frame.
2. Place the wheel stop (4) onto the long
end of the axle.
3. Place one wheel (1) onto the axle (5)
with the bolt design facing out.
4. Install one washer (3) onto the axle.
5. Install one 12 mm locking nut (2) onto
the axle and tighten securely.
6. Repeat steps 3 – 5 for the other wheel.
7. Remove the blocking.
1
4
3
2
5
3
4
2
1
1
2
2
1