User Manual

C20E Model 641745
5
SQUEEGEE ASSEMBLY INSTALLATION
1) Disconnect the power.
2) Loosen the 2 knobs on the squeegee assembly.
3) Connect the vacuum hose to the vacuum hole in the
squeegee assembly.
4) Align the knobs with the slots and tighten the knobs.
PAD DRIVER/BRUSH INSTALLATION
WARNING - The Pad Driver has sharp hook and loop-type
surface grips for attaching scrubbing pads. Wear leather work
gloves while setting up the Pad Driver/Brush.
1) Turn the Key to the OFF position and disconnect the power cord
from a power source.
2) Attach Scrubbing Pad to the Pad Driver if Pad Driver is used.
3) Place the Pad Driver/Brush under the head assembly.
4) Lower the Pad Driver/Brush Head Assembly to the floor by
stepping on the Head Assembly Foot Pedal, guiding the
pedal to the left, and letting it rise up to disengage it.
Remove your foot from the pedal.
5) Line up three studs on top of the Pad Driver/Brush to
the holes on the head assembly. Lift up the Pad
Driver/Brush to insert the three studs into the holes of
the head assembly and turn clockwise to lock them.
6) Power on the machine by connecting the power cord
to a power source and turning the Key to the ON
position.
7) Turn on the Pad Driver/Brush with the
pad driver/brush button so that the Pad Driver/Brush
locks in completely.
8) To remove the Pad Driver/Brush, disconnect the
power and wiggle the pad driver/brush back and forth
clockwise/counterclockwise until it becomes loose.
Knobs
Engaged Pedal (Lowest position)
Guide pedal to this position to
raise the Pad Driver/Brush Head
off floor. Guide pedal out of this
position to lower the Pad
Drive/Brush Head.