User guide

SEBU7858-03 25
Safety Section
Tire Information
•
walkways
•
front side door of engine hood
Do not weld a bracket on the Rollover Protective
Structure (ROPS) in order to install the fire
extinguishe
r. Also, do not drill holes in the ROPS in
order to mount the fire extinguisher on the ROPS.
i01557411
Tire Informatio n
SMCS Code: 7000
Explosions of air inflated tires have resulted from
heat-induced gas combustion inside the tires.
Explosions can be caused by heat that is generated
by welding, by heating rim components, by external
fire, or by excessive use of brakes.
A tire explosion is much more violent than a
blowout. The explosion can propel the tire, the rim
components, and the axle components as far as
500 m (1500 ft) or more from the machine. Both the
force of the explosion and the flying debris can cause
property damage, personal injury, or death.
g003
37832
Illustration 27
(A)Atleast15m(50ft)
(B) A t least 500 m (150 0 ft)
Do n
ot approach a warm tire. Maintain a minimum
distance, as shown. Stay outside the shaded area in
Illustration 27.
Do not use water or calcium as a ballast for the tires.
Dry nitrogen gas is recommended for inflation of tires.
If
the tires were originally infl ated with air, nitrogen
is still preferred for a djusting the pressure. Nitrogen
mixes properly with air.
Nitrogen inflated tires reduce the potential of
a tire explosion because nitrogen does not aid
c
ombustion. Nitrogen helps to prevent oxidation of
the rubber, deterioration of rubber , and corrosion of
rim components.
To avoid overin
flation, proper nitrogen inflation
equipment and training in the usage of the equipment
are necessary. A tire blowout or a rim failure can
result from im
proper equipment or from misused
equipment.
When you infla
te a tire, stand behind the tread and
use a self-attaching chuck.
Servicing t
ires and rims can be dangerous. Only
trained personnel that use proper tools and proper
procedures should perform this maintenance. If
correct pro
cedures are not used for servicing tires
and rims, the assemblies could burst with explosive
force. This explosive force can cause serious
personal i
njury or death. Carefully obey the specific
instructions from your tire dealer.
i01122596
Electrical Storm Injury
Prevention
SMCS Code: 7000
When lightning is striking in the vicinity of the
machine, the operator should never attempt the
following procedures:
•
Mount the machine.
•
Dismount the machine.
If you are in the operator's station during an electrical
storm, stay in the operator's station. If you are on the
ground during an electrical storm, stay away from
the vicinity of the machine.
i03140043
Before Starting Engine
SMC
S Code: 1000; 7000
Start the engine only from the operator's
com
partment. Never short across the starter
terminals or across the batteries. Shorting could
bypass the engine neutral start system. Shorting
co
uld also damage the electrical system.