Full Product Manual

If the clamps are INCORRECTLY connected with regard to polarity, the LCD screen will display the

following (the “+” and “–” inside the battery icon and the fault icon will flash and the clamp icons,

the battery icon and the gauge without the pointer will light) and a warning will sound until the

clamps are disconnected:

Unplug the charger; then remove the clamps. Reconnect the clamps properly.

3. When the unit is properly connected, press the battery charge button on the control panel. The LCD

screen will display the following:

The digital display shows the output current that is charging the battery. The gauge indicates the

charge status of the battery. The clamp icons and the battery icon light solid, the bars on the battery

icon will change from empty to solid (bottom to top) repeatedly and the arrow icons will gradually

and repeatedly move downward to the battery icon.

Notes:

The “ ” icon will appear at the top right of the gauge section if the surrounding ambient

temperature is higher than approximate 40°C. The “ ” icon will appear at the top left of the gauge

section if the surrounding ambient temperature is lower than 0°C. This is not a fault code, but

indicates that the unit’s temperature compensation feature is operating.

The charging process will start automatically approximately one minute after the unit is properly

connected.

Important:

If the unit is overheated, the LCD screen will display the following (the fault icon will

flash; and the overheat alarm icon, the battery icons, arrow icons and the gauge without the pointer

will light):

Disconnect the charger and allow the charger to cool for several minutes. Make sure there is

adequate ventilation around the unit before attempting to charge again.

Important:

The charger will automatically detect the battery condition. If it detects a problem with

the battery, the LCD screen will display the fault indication icon (the fault icon will flash; and the

overheat alarm icon, the battery icons, arrow icons and the gauge without the pointer will light):

Disconnect the charger. Have the battery checked by a qualified technician.

IMPORTANT:

If the battery is not fully charged (the battery charge gauge does not reach 100%)

after 18 hours of continuous charging, the battery may have internal damage and will not accept a

charge. After 18 hours, the charging process will automatically cut-off, the LCD screen will display