Manualshelf

Full Product Manual

ManualsBrandsCAT ManualsAutomotiveProfessional Rolling 40 Amp Battery Charger, 3 Amp Maintainer with 200 Amp Engine Start
11121314151617181920
11
11
the following (the digital readout shows “F04”, the clamp icons, arrow icons, battery icon and the
gauge without the pointer will light solid - the fault icon will flash):
Disconnect the charger. Have the battery checked by a qualified technician.
4. When the battery is completely charged, the unit automatically goes into float charge mode and the
LCD screen displays the following:
The digital display shows “FLO” to indicate that the unit is in float charge mode. The battery charge
gauge points to 100%, indicating a full charge. The clamp icon and battery icon with four bars light
solid, and the arrow icons will gradually and repeatedly move downward to the battery icon. In
this mode, the unit monitors the battery voltage and charges as necessary to assure the battery
maintains full capacity. The unit remains in float charge mode as long as the charger is connected to
the battery and plugged into a functioning AC outlet.
When disconnecting charger, disconnect the AC cord, remove clamp from vehicle chassis, and then
remove clamp from battery terminal.
Checking the Battery Voltage
TO CHECK THE BATTERY VOLTAGE IN STANDBY MODE
1. Set up the battery charger and connect to the battery following steps 1 through 2 in the “Charging
the Battery” section.
2. Press the battery voltage check button. The LCD screen will display the following:
The digital display shows the current voltage of the connected battery for 10 seconds. During this
period, pressing the battery voltage check button again will return the unit to standby mode. The
gauge without the pointer will light solid. The unit will automatically return to standby mode after 10
seconds.
TO CHECK THE BATTERY VOLTAGE IN CHARGING MODE:
Press the battery voltage check button and the LCD screen will display the following:
The digital display shows the current voltage of the connected battery for 10 seconds. During this
period, pressing the battery voltage check button again will return the unit to charging mode.
The unit will automatically return to charging mode after 10 seconds.
When disconnecting charger, disconnect AC cord, remove clamp from vehicle chassis, and then remove
clamp from battery terminal.