Use and Care Manual

4 5
4 5
5
PRE-DRILLED SCREW HOLE
FOR MOUNTING METAL PLATES
(TOTAL OF 4: 2 ON THE LEFT
AND 2 ON THE RIGHT)
UNDER RUBBER CAP (ABOVE)
WITH CAP REMOVED TO SHOW DETAIL (LEFT)
METAL PLATES
SCREWS FOR MOUNTING
METAL PLATES (X4)
O-RING WITH CABLES AND
SLIDE-IN CONNECTORS
WING NUTS AND BOLTS FOR
PERMANENT INSTALLATION
BOLT (X2)
WASHER (X2)
WING NUT (X2)
HOW THIS INVERTER WORKS
This inverter is an electronic device that converts low voltage DC (direct current) electricity from a
battery to 120 volts AC (alternating current) household power. It converts power in two stages.
The first stage is a DC-to-DC conversion process that raises the low voltage DC at the inverter input
to 145 volts DC. The second stage is a MOSFET bridge stage that converts the high voltage DC into
120 volts, 60 Hz AC.
Power Inverter Output Waveform
The AC output waveform of this inverter is known as a modified sine wave. It is a stepped waveform
that has characteristics similar to the sine wave shape of utility power. This type of waveform is suitable
for most AC loads, including linear and switching power supplies used in electronic equipment,
transformers, and small motors.
CAUTION – Rechargeable Devices
• Certain rechargeable devices are designed to be charged by plugging them directly into an AC
receptacle. These devices may damage the inverter or the charging circuit.
WARNING: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: Follow these instructions
and those published by battery manufacturer and the manufacturer of any equipment you intend to use
with this unit. Review cautionary markings on these products and on engine.
INTRODUCTION
Congratulations on purchasing your new Cat
®
1000 Watt Power Inverter . Read this Instruction
Manual and follow the instructions carefully before using your new inverter.
This power inverter is configured to supply continuous power in the form of two 120 volt AC outlets and
two 5 volt USB charging ports to run most household or electronic appliances.
Controls and Functions
THREE-PRONG 120
VOLT AC OUTLETS
VENTILATION SLOTS
USB CHARGING PORTS
1000W LED
INDICATOR
100W LED INDICATOR
ON/OFF BUTTON AND
POWER/FAULT INDICATOR
MOUNTING BRACKETS
(TOTAL OF 4: 2 ON THE
LEFT AND 2 ON THE RIGHT)
(RED) POSITIVE
CABLE POST
(UNDER CAP)
(BLACK) NEGATIVE
CABLE POST
(UNDER CAP)
HIGH-SPEED
COOLING FANS
(RED) POSITIVE POST
GROOVE
DC PORT (FOR USE WITH THE
12V DC VEHICLE ADAPTER PLUG)
(BLACK) NEGATIVE
POST GROOVE
12V DC VEHICLE ADAPTER
PLUG WITH DC DOUBLE-
BARREL CONNECTOR
BATTERY CLIPS WITH CABLES AND SLIDE-IN
CONNECTORS
CPI1000_ManualENSP_101713.indd 4-5 10/17/2013 11:22:31 AM