SDS

THE COPYRIGHT BELONGS TO TINNO MOBILE TECHNOLOGY CORP.
2019-11-18
All Rights Reserved
Page 12 of 41 Pages
0.2C5A to the cut-off voltage under 23℃±2℃. The charge
and discharge test can be repeated for 5 times.
选取生产日期不足 3 个月的电池，保持电压在 3.85~3.90V，在
温度 20±5℃，湿度 45%~85%的条件下，储存 12 个月后，然后
按照标准模式进行充电，在 23℃±2℃的环境温度下以 0.2C
5
A
电流放电到终止电压，充放电实验可以循环 5 次.
5
、
Environmental performance
环境性能
测试项目
测试方法 Method
检验标准 Criteria
Constant
humidity
and heat
performance
恒定湿热性
能
After standard charging, the battery is put into a constant humidity box
with a temperature of 40±2℃ and a relative humidity of 90%~95% to be
stored for 48h. The battery is removed and stored for 2 hours at an
ambient temperature of 23℃±2℃ to check its appearance. Then it is
discharged at a current of 0.2A until reaching cut-off voltage of 3.0V
电池标准充电后放入温度 40±2℃、相对湿度（90%~95%）的恒湿
箱中搁置 48h，将电池取出在 23℃±2℃的环境温度下搁置 2 小时，
检查电池外观，然后以 0.2C5 电流放电至终止电压 3.0V。
The discharge time of
residual capacity shall be
≥4.5h, swelling rate≤ 5%.
No swelling or leakage.
剩余容量放电时间≥4.5h，电
池厚度变化率≦5%、电池不膨
胀、不渗漏；
ESD test
ESD 测试
After battery standard charging, 8KV is used to conduct contact
discharge at the battery. Battery is continuously discharge for 10 times,
with an interval of 1s. 12KV is used to conduct air discharge on the
weak insulation position of the battery. Battery is continuously discharge
for 10 times, with an interval of 1s.电池标准充电后，使用 8KV 对电池
的每个金属接触点进行接触放电；连续进行 10 次放电，每次放电间
隔时间为 1s。继续使用 12KV 对电池较薄弱的绝缘位置进行空气放
电；连续进行 10 次放电，每次放电间隔时间为 1s。
Battery has no abnormality
and the electrical
performance is normal.
要求电池无异常，电性能正常
Low pressure
低气压
After standard charging, the battery was placed in a vacuum box
at an ambient temperature of 23
℃
±2
℃
. After the box was closed,
the internal pressure was gradually reduced to no more than
11.6kpa. Battery is stored in such environment for 6h. Then it is
taken out to be placed in an open circuit for 1h. (simulated altitude
of 15240m)
电池标准充电结束后，在 23℃±2℃的环境温度下，将其搁置在真空
箱中，真空箱密闭后，逐渐减少其内部压力至不高于 11.6kPa，开路
放置 6h（模拟海拔 15240m），然后取出电池，开路搁置 1h，观察电
池状态。
No obvious damage, no
swelling, no leakage, no
venting, no crack, no fire,
and no explosion.
要求电池外观无明显损伤，不
膨胀、不漏液、不泄压、不破
裂、不起火、不爆炸.
High
temperature
storage
高温存储
After standard charging, the battery is stored for 2h, and have
thickness measured. Under the condition of 70℃±2℃, the battery
is stored for 16h. Then, the battery was taken out to be stored for
2h. Battery thickness is measured. Finally, the battery is charge
and discharge at 0.2c current for 1 time. Recording discharge
Swelling rate≦8%, the
discharge time of recovered
capacity> 4.75h. No obvious
difference on battery surface before
and after test.