Instructions / Assembly

Assembly Instructions (cont.)
Step 2:
Align two corner holes of Fire Pit Surround Ring (C) with two
holes of Leg (H) and loosely fasten with small screws and
nuts (Figure 1). DO NOT FULLY TIGHTEN SCREWS at this
point. Repeat step for three remaining legs.
Step 3:
Place Leg Support Ring (A) over assembled legs by aligning
holes of each (Figure 2). Attach Leg Foot (I) to all four Legs
(Figure 3). Hand tighten Feet securely in place.
Turn assembled stand over.
Tighten ALL stand hardware with screwdriver and wrench.
Step 4:
Place Fire Bowl on Stand (Fig 5).
Step 5:
Place Tiles (D) around ledge of Fire Pit Surround (Figure 6).
Step 6:
Place Spark Screen (G) on bowl (Figure 7).
Figure 1 Figure 2
Figure 3 Figure 4
Figure 5 Figure 6
Figure 7 Figure 8
• Fire bowl may be cleaned with water and mild detergent.
• Do not use abrasive detergents or pads to clean surround or re bowl.
• As with any outdoor grill, periodic maintenance is required to
return painted steel surfaces to original appearance. Remove any
rust with sandpaper or steel brush and repaint with grill paint suitable
for high-temperature surfaces. Follow manufacturer’s instructions.
• Maintenance is required before or after every season of use.
General Care Instructions
Please contact us if you have any problems or questions regarding this product.
Email: [e-mail]
Toll Free: [phone], M-F, 9 a.m. - 5 p.m. EST.
Customer Service
AD586OM (7/12)