Use and Care Manual

ManualsBrandsCatalina Creations ManualsOutdoorsCopper and Slate Mosaic Fire Pit

Slate Mosaic Fire Bowl

Models: AD658C, AD658S

Important! Please read and follow ALL instructions before assem-

bling or using this product, particularly the safety statements. Failure to follow

instructions and warnings could result in damage to property or serious injury.

AD658C/S OM (7/12)

Summary of content (4 pages)

PAGE 1
Slate Mosaic Fire Bowl Models: AD658C, AD658S Important! Please read and follow ALL instructions before assemAD658C/S OM (7/12) bling or using this product, particularly the safety statements. Failure to follow instructions and warnings could result in damage to property or serious injury.
PAGE 2
READ AND FOLLOW ALL SAFETY STATEMENTS, WARNINGS, ASSEMBLY INSTRUCTIONS AND USE & CARE DIRECTIONS BEFORE ASSEMBLING OR USING THIS PRODUCT. ! WARNING ! • Outdoor use only. Never use in enclosed area. Use in unventilated areas will endanger your life. • Do not use this unit on or near combustible surfaces or structures such as wood or composite decks, dry leaves or grass, mulch or vinyl or wood siding, etc. • Use on level, non-combustible surface only.
PAGE 3
General Care Instructions • Fire bowl may be cleaned with water and mild detergent. • Mosaic surround may be sealed with exterior tile sealer if desired. • Fire bowl will change colors after use, this is normal and expected. • Do not use abrasive detergents or pads to clean bowl or surround. • As with any outdoor grill, periodic maintenance is required to return painted steel surfaces to original appearance.
PAGE 4
Assembly Instructions Figure 1 Figure 2 Figure 3 Figure 4 Step 1: Carefully unpack all parts. Inspect for missing parts or damage. Step 2: Interconnect the two (2) Cross Bars (E) and fasten together with one (1) Phillips Head M6X20mm Bolt (H1) and Hex Nut (H2) (Figure 1). Loosely hand tighten hex nut only. Do not completely tighten cross bars. Step 3: Loosely connect one end of Cross Bar assembly to one Leg (D) (Fig. 2) with one (1) Phillips Head M6X12mm Bolt (H). Loosely tighten bolt only.