Use and Care Manual

Assembly Instructions
Step 1:
Carefully unpack all parts. Inspect for missing parts or damage.
Step 2:
Interconnect the two (2) Cross Bars (E) and fasten together with
one (1) Phillips Head M6X20mm Bolt (H1) and Hex Nut (H2)
(Figure 1). Loosely hand tighten hex nut only. Do not completely
tighten cross bars.
Step 3:
Loosely connect one end of Cross Bar assembly to one Leg (D)
(Fig. 2) with one (1) Phillips Head M6X12mm Bolt (H). Loosely
tighten bolt only. Note: Completely tightening bolt may make it dif-
cult to complete Step 4.
Repeat step until all four ring legs are in loosely fastened in place
completing the stand assembly. Do not tighten hardware.
Step 4:
Once the stand is fully assembled, carefully place the Mosaic Sur-
round (C) tile side down. Align holes of completed leg stand as-
sembly to holes on underside of surround. Loosely attach legs to
surround with two (2) Phillips Head M6X20mm Bolt (H1) through
each leg (Fig. 3).
Once the stand is fully assembled and all hardware is in place,
tighten all stand hardware with a Phillips Head Screwdriver. Be
careful not to strip the bolts by overtightening.
Step 5:
With help, carefully turn assembled stand surround over (Fig. 4).
Place Fire Bowl (B) in center of surround. Place Log Grate (F) in
bottom of re bowl. Place Spark Screen (A) on re bowl (Fig. 5).
OUTDOOR USE ONLY ON NON-COMBUSTIBLE SURFACE
ONLY. READ ALL SAFETY WARNINGS BEFORE USE.
Figure 1
Figure 4Figure 3
Figure 2
Figure 5