Specification

Thomas and Betts Corporation
Product Guide Specification
WIRE AND CABLE FASTENING
26 05 84-2
REVISION 0
B. Product Data:
1. Submit manufacturer’s descriptive literature and product specifications for each product.
2. Manufacturer’s product drawings.
C. Manufacturer’s installation instructions.
1.04 QUALITY ASSURANCE
A. Manufacturer Qualifications: Products shall be free of defects in material and workmanship.
B. Furnished products are listed, recognized or classified by third party agencies as being suitable for
the intended purpose.
1.05 WARRANTY
A. Product is warranted free of defects in material and workmanship.
B. Product is warranted to perform the intended function within design limits.
PART 2 – PRODUCTS
2.01 GENERAL
A. Cable ties and support systems shall be UL Listed, UL Recognized and/or CSA Certified where
stated below in the DESIGN AND PERFORMANCE REQUIRMENTS section.
B. Cable ties and support systems shall be used with the ERG series installation tool to ensure proper
assemblies.
C. Cable ties and support systems shall be approved for nuclear facilities as commercial grade product.
2.02 MANUFACTURERS
A. Acceptable Manufacturers:
Thomas & Betts Corporation
8155 T&B Blvd
Memphis, TN 38125
800-816-7809, 901-252-5000
www.tnb.com
Product: Ty-Rap® Cable Ties
2.03 DESIGN AND PERFORMANCE REQUIREMENTS
A. Standard nylon 6.6 cable ties (TY523M series):
1. Standard cable ties shall be molded from nylon 6.6 material.
2. Standard nylon 6.6 cable ties shall have a non-magnetic stainless steel locking device.
3. Standard nylon 6.6 cable ties shall have a smooth, notchless body.
4. Standard nylon 6.6 cable ties shall have a turned up tail.
5. Standard nylon 6.6 cable ties shall be available in natural, black, brown, red, orange, yellow,
green, blue, purple, gray and beige colors.
6. Colored and black standard nylon 6.6 cable ties shall be UV stabilized.
7. Standard nylon 6.6 cable ties shall have tensile strength ratings of 18 lbs, 30 lbs, 40 lbs, 50
lbs, 120 lbs and 175 lbs.
8. Standard nylon 6.6 cable ties shall be rated -40ºF to 185ºF (-40ºC to 85ºC), UL94V-2.