P rofes s i o n a l Su p p l i e s ELECTRIC WATER BOILER Modelnr.: *688.120 OPERATION MANUAL Before using water boiler, read all instructions below.
TABLE OF CONTENTS 1 2 3 4 5 6 7 8 Specifications Structure Installation Operation Instruction Attention and Maintenance Circuit Diagram Maintenance Chart and Components Working Flow 1. SPECIFICATIONS Dimension (mm) Voltage (V) Power (W) Tank Capaclty Water Supply (L) (L/H) Temperature (°C) 210 x 400 x 450 230 2600 7 30 90-95 225 x 430 x 680 230 2600 14 36 90-95 2. STRUCTURE 3. INSTALLATION A This machine must be connected with the right power supply.
4. OPERATION INSTRUCTION A B C D E Connected water supply and inlet with ½ inch pipe. Put the plug in the socket. Switch on and the light is on. The water flow into the thermos after 1 minute to keep warm. The boil-water machine will stop boiling automatically when no water in the tank or the tank is full. But the tank is keeping warm. 5. ATTENTION AND MAINTENANCE A Pull the plug out of the socket if do not use for a long time. B A little water will be left in the tank.
7.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 TOP COVER BOARD COVER BOARD FOR INTERNAL WATER TANK FLOATING SWITCH ELECTROMAGNETICALLY OPERATED VALVE INVARIANT CODE OF ELECTROMAGNETICALLY OPERATED VALVE OUTLET FOR HOT-WATER RUBBER WATER PIPE TEMPERATURE CONTROL BACK BOARD SCREW HIGH TEMPERATURE CORD SWITCHING KEY COVER FOR HOT-WATER KETTLE HEATING ELEMENT (HOT-WATER KETTLE PIPE) BODY OF HOT-WATER KETTLE PIPE LINK BANK POWER CORD INLET PLUG PLASTIC FEET BOTTOM B
8. WORKING FLOW: Turn on the power switch, water level inductor in the insulated cabinet produces signal when the water level is falling. The heater (boiling cup) starts to heat until the water boil. Then the boiled water inflows into the insulated cabinet from the upper water pipe. There are heating elements and thermostat switch at the bottom of the insulated cabinet in order to keep water temperature 95°C. The water level switch in the cool water tank will produce a signal if water level is low.