User manual

You can use your device for emergency calls in the service area. The
connection, however, cannot be guaranteed in all conditions. You
should not rely solely on the device for essential communications.
Certification Information (SAR)
This device meets guidelines for exposure to radio waves. Your device
is a low-power radio transmitter and receiver. As recommended by
international guidelines, the device is designed not to exceed the limits
for exposure to radio waves. These guidelines were developed by the
independent scientific organization International Commission on Non-
Ionizing Radiation Protection (ICNIRP)
and include safety measures designed to ensure safety for all users,
regardless of age and health. The Specific Absorption Rate (SAR) is the
unit of
measurement for the amount of radio frequency energy absorbed by
the body when using a device. The SAR value is determined at the
highest certified power level in laboratory conditions, but the actual
SAR level of the device when being operated can be well below the
value. This is because the device is designed to use the minimum
power required to reach the network.
The SAR limit adopted by USA and Canada is 1.6 watts/ kilogram
(W/kg) averaged over one gram of tissue. The highest SAR value
reported to the FCC and IC for this device type when tested for use at
the ear is 0.738 W/kg, and when properly worn on the body is 0.561
W/kg.
The SAR limit also adopted by Europe is 2.0 W/kg averaged over 10
grams of tissue. The highest SAR value for this device type when
tested at the ear is 0.547 W/kg, and when properly worn on the body is
0.346 W/kg.
FCC Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.