User manual

Cat

S50c Smartphone User Manual

Securing microSD/SIM cover

Follow the below steps to keep your phone protected from water and dust damage.

1. Insert the end of the cover with out the screw, first.

2. Next, insert the end of the cover with the screw.

3. Ambient light Finally, using a coin or flat screwdriver turn screw until secure, 6-7 complete 360-degree turns.

Note:

Turning more than 7 times can cause damage to the screw and cover.

Charging the Battery

The S50c has an embedded battery, to charge the battery:

1. Connect the USB cable that came with your mobile phone to the charger.

Note:

Use only Cat

phone approved chargers and cables. Unapproved equipment may cause damage to the

device

or cause batteries to explode.

2. Open the USB port cover. Connect the USB cable to the USB port of your phone.

Note:

Be careful not to use excessive force when plugging the USB cable.

Be aware of the correct orientation of the plug. Damage can be caused by attempting to insert the

connector

incorrectly, this is not covered by the warranty.

3. Connect the USB to the appropriate AC main plug and connect safely to the main power supply.

4. When charging is complete, remove the connector from the device and then remove the wall charger.

Note:

If the battery is completely discharged, it may take a few minutes before the charging icon appears.