User's Manual

An Electronic Key with Standard Access Level
and a Non-electronic Key
• The table of the MSS keys can be viewed but the
table cannot be modified.
• The configuration settings of the MSS can be
viewed but the settings cannot be modified.
Electronic Key with Master Access Level
A factory password or a master access level is
needed to modify any settings through the service
tool.
• The settings for the MSS can be modified.
• The list of valid key IDs can be modified.
• The logged events can be cleared.
i06222298
Service Operation Using
Machine Security System
SMCS Code: 7631
The onboard interface has several purposes. The
interface can provide the following information to the
operator: diagnostic feedback and event feedback.
The system can also be programmed through the
onboard interface.
i06222303
Service Operation Using
Service Tool
SMCS Code: 0785-UE; 7631
The service tool is used to communicate with the
ECM for the following information:
• display and control of code
• programming
• management
• diagnostics
• events
To protect the machine properly, the service tool
requires a factory password or a key with the master
access level. This password or key is required before
any modifications can be made to the MSS.
i06222310
Electronic Control Module
(ECM)
SMCS Code: 7610-MCH
FCC NOTICE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Industry Canada Notice to Users
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
14 UENR7061
Systems Operation Section

Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage,
et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnemen