User's Manual

Illustration 40 g03866205
Typical ET screen
3. Highlight the “Security System Bypass Start Time”
for the day that you want to set up. Press the
“Change” push button at the bottom of the page.
This button will bring up the “Change Parameter
Value” screen.
4. Enter the desired “start time” in the space that is
provided. Then click the “OK” button.
All times are based on a 24 hour clock. If you want
the desired start time to be 6:00 am, then enter
06:00. If you want the desired start time to be 6:00
pm, then enter 18:00. Include the colon in the time
setting or the MSS will not accept your entry.
5. Highlight the “Security System Bypass Stop Time”
for the same day. Press the “Change” push button
at the bottom of the page. This button will bring up
the “Change Parameter Value” screen. Enter the
desired “stop time” in the space that is provided
and click the “OK” button.
6. Repeat Steps 3 and 5 for all days which should
have Bypass Activation Times.
7. To have the MSS armed 24 hours a day, repeat
Steps 3 and 5 entering 00:00 as the “Start time”
and 00:00 as the “Stop time” .
Note: All times are based on a 24 hour clock. The
Machine Security System automatically adjusts for
Daylight Savings Time (DLST). If Daylight Savings
Time is not observed in your area, you will need to
reset the time in the MSS. The time change occurs
on the first Sunday in April and the last Sunday in
October. If DLST changes on a different date in your
area than in the United States, you will need to reset
the time on that day. Refer to Testing and Adjusting,
“Time - Set” for instructions on setting the date and
the time of the MSS.
i06227251
Factory Password - Obtain
SMCS Code: 7631-554-XW
You may use the following methods to obtain a
factory password. The first method is via the Factory
Password System (FPS) via the Internet. The second
method is via the telephone help line. The
procedures for both methods are listed in the
following sections.
UENR7061 79
Testing and Adjusting