User's Manual

 The maximum torque for the mounting bolts is 12 N·m (as per 1E0279B).
 Do not mount on a cantilever
 Do not mount on a flexible surface
 Must be mounted on a flat surface
 Place the PL161 in an area that is easily accessible and can be serviced in a
reasonable amount of time.
 Place the PL161 in an area and with an orientation that it is not used as a "boot
step" or a "fulcrum point".
PL161 Environmental Information
PL161 Environmental Information Table
Parameter Specification
Operating Temperature Range −40°C to 85°C
Storage Temperature Range -50°C to +95°C
Vibration 29.59 Grms
Ingress Protection IP68 (35kPA)
Table2
Installing the PL161
The PL161 has two mounting options, adhesive mount or hard mount.
Note:
Avoid mounting the device next to high heat sources such as exhaust stacks.
Note:
Avoid mounting the device in a transmitted beam of any radar equipment. For
best adhesion, the PL161 should be mounted at temperatures between
21° C (69.80°
F)
and 38° C (100.40° F).
Adhesive Mount Option
Note: Refer to "PL161 Mounting Requirements" before mounting the device.
The PL161 comes with two strips of adhesive tape loose in the kit.
Note:
For best adhesion, the PL161 should be mounted at temperatures between 21°
C
(69.80° F) and 38° C (100.40° F) and the device should be mounted to a clean/dry
area.