User's Manual

1. Record all the data needed to subscribe services in the "DSP" before mounting
the Product Link device. Refer to "Record the Registration Information".
2. Remove the strip of protective plastic from one side of each adhesive strip.
3. Apply one piece of adhesive tape to each side of the back of the PL161.
4. Remove the remaining strip of protective plastic from each of the adhesive
strips.
5. Firmly press the radio down on the mounting surface.
Hard Mount Option
Note: Refer to "PL161 Mounting Requirements" before mounting the device.
1. Record all the data needed to subscribe services in the "DSP" before mounting
the Product Link radio. Refer to "Record the Registration Information".
2. Clean off an appropriate sized area to weld the mounting plate to.
3. Weld the mounting plate to the surface.
4. Apply thread locker to each bolt (1E2200L or 1E2200A)
5. Bolt the PL161 onto the mounting plate using the provided bolts. Tighten the
mounting hardware to
12 ±3 N·m (8.851 lb ft).
