User's Manual

12. When the “Network and Dial-up
Connections” screen appears:
a
. Right-click on the “Local Area
Connection” option that has a device
name of “Wireless PC Card Model
0111”.
b
. Click “Properties”.
NOTE: If the screen does not display in the
“Details” view as shown, click on the Views
icon and click “Details”.
13. Alter and record the IP Address number
by adding 10 to the third and fourth sets
of numbers of the IP address. For
example, if the number on the adapter is
172.23.1.31, the new number would be
172.23.11.41.
NOTE: The first and second sets of numbers
of the IP Address will always be 172 and 23.
The third and fourth sets of numbers in the IP
address must not be the same as any other IP
address in the local area network (LAN) or
other Wireless Communication Adapters.
Also, the numbers 0 and 255 cannot be used
for the third and fourth set of numbers. It is
highly recommended that the Network
Administrator manage all IP Addresses of
Wireless Communication Adapter modules and
PC’s configured for use with Wireless
Communication Adapters.
NOTE: If the factory default IP Address on the
Wireless Communication Adapter has been
changed, refer to the Contact Information
section at the front of this manual.
14. When the “Local Area Connection
Properties” screen appears:
a. Scroll down and click on “Internet
Protocol (TCP/IP)” option.
b. Click “Properties”.
15. When the “Internet Protocol (TCP/IP)
Properties” screen appears:
a. Select “Use the following IP address:”.
b. Enter the altered IP Address number
from Step 13.
c. Verify that the “Subnet mask:” is
255.255.0.0.
d. Click “OK”.
21