Operation Manual

10
Introduction
How to install the
unit on your bicycle
Setting up the
computer
Others
Changing the
computer con-
figuration
Uploading the mea-
surement data
Setup of your
PC
How to use the
computer
Resetting the measurement data and generating
the trip data
Holding down the MODE button with the measurement screen
displayed resets the measurement data to 0 (resetting operation).
All the measurement data up to that time are generated as trip data.
You can view measurement results and store trip records, by up-
loading the trip data to the special website “CATEYE Atlas™” via the
dedicated software application “CATEYE Sync™”.
1 day
2 day
3 day
4 day
5 day
6 day
Trip data for the 1st
day are generated.
Trip data to
be generated
Resetting
operation
Trip days
Trip data for the 2nd day to the
4th day are generated.
Trip data is not yet generated.
MODE
Resetting
operation
MODE
Resetting
operation
* A trip is continued unless the resetting operation is performed, even if the power is turned
off during measurement.
* The trip distance-2 (Dst2) is not reset to 0, since it is to be reset separately.
For details, see “Resetting the trip distance-2” below.
* The total distance (Odo) cannot be reset.
* For information on how to upload to the CATEYE Atlas™, see “Uploading the measurement
data (trip data)” (page 13).
* The unit has a limited memory capacity. When the data volume exceeds the memory capaci-
ty, any new data can no longer be stored. For details, see “Record interval and capacity limit”
(page 16).
Resetting the trip distance-2
Pressing and holding the MODE button with the trip distance-2
(Dst2) displayed resets only the trip distance-2 data to 0.
* The trip distance-2 ( Dst2 ) value cannot be saved as trip data.
MODE
MODE
(press & hold)
(press & hold)