Operation Manual

14
Introduction
How to install the
unit on your bicycle
Setting up the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
Others
How to use the
computer
Middle
display
GPS
signal
Speed
signal
Description
Clock
Altitude
watt
Power
(Flash) (S off)
In this state, the unit uses the speed signal for mea-
surement. It cannot display altitude acquired from
the GPS signal and cannot record route information.
* Altitude are displayed and route information can be
recorded from the time the GPS signal is received.
(On) (S off)
In this state, the unit uses the GPS signal for mea-
surement, displays altitude, and allows route infor-
mation to be recorded.
* If the GPS signal is lost while riding, the GPS sig-
nal not received icon (
) will flash and the unit
will stop measurement. Measurement will resume
when the GPS signal is received again.
(On)
S
(Flash)
In this state, the unit give priority to the speed signal
for measurement. It uses the GPS signal to display
altitude, and record route information.
* For information on how to start/stop measurement, view the measurement data, and about
resetting operation, see “Functions available on the measurement screen” (page 16).
* When the unit is on the measurement screen, if there is no button operation for 10 minutes
while the GPS signal and/or the ANT+ sensor signal is not received, the unit automatically
turns off. (Auto power off)
GPS signal may not be received, thus the unit may stop measurement or may not dis-
play appropriate measurements in the following locations or environments.
• In a tunnel, underground and building, between high-rise buildings, under an elevated
structure and arcade, etc.
• In bad weather (snow, rain, etc.)
• Near a high-voltage line or a mobile telephone relay station.
• When the computer display does not face to the sky.
MODE
GPS search screen
Measure-
ment screen
Power OFF
Speed unit
Changed automatically
Changed by operating
buttons
GPS signal
To be changed according to the
GPS signal receiving status.
Speed signal
S
GPS signal or
speed signal
received
Switches to measurement
screen when GPS signal
and/or speed signal can-
not be received
* STOP is displayed when
GPS is not received.
Clock
0:00 – 23:59
[AM1:00 – PM12:59]
(Press & hold)
Power
ON/OFF
Standby screen
MODE
No operation
for 10 minutes
No operation
for 10 minutes
or
No opera-
tion for 50
minutes
Measurement
starts
Measurement
stops
GO
STOP
* When GPS signal or speed signal is not received,
measurement will not start even if the button is
pressed and GO is displayed.
Current speed
0.0 (3.0) – 105.9 km/h
[0.0 (2.0) – 65.9 m/h]
Selected data
Press &
release