Operation Manual

30
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Others
Changing the
computer
configuration
You can change the computer configuration in two ways.
• Changing the setting with CATEYE Sync™ (below on this page)
You can change the configuration easily from your PC application, with the computer con-
nected to your PC with the cradle.
Caution: Pairing the ANT+ sensor cannot be performed with CATEYE Sync™. For
information on how to perform, see “Pairing the sensor” (page 36).
• Changing the settings of the computer alone (page 33).
This can be used when changing the setting with not using a PC.
Changing the setting with CATEYE Sync™
1
Set the computer to the cradle
Caution: Do not set wet computer to the
cradle, for example after ride in the
rain. It may cause short circuit and
damage the computer or the data.
2
Insert the USB plug into your PC
Only (battery icon) is displayed on the computer screen.
3
Start CATEYE Sync™
Double-click on the shortcut [CATEYE Sync™] to start CATEYE Sync™.
Click the button, then a browser will open and a
video will be played back.
Watch video
(YouTube)
Changing the computer configuration
4
Click on [Settings]
The setting screen appears.
Cradle
Computer