Operation Manual

31
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Others
Changing the
computer
configuration
6
Click on [STEALTH] to change the settings
Before changing the settings, click on [Read] to load the settings of the computer.
Change the settings according to the following procedure.
Setting items Description
Time zone
Select the city code nearest from your current location.
* For details, see “Time zone list” (page 11).
Daylight saving
time
Select whether to use the daylight saving time.
• On : Moves the clock 1 hour ahead.
• Off : Displays in regular clock.
Speed unit Select the speed unit (km/h or m/h).
Setting items Description
Night-time
setting
Set the time when the backlight lights up.
• Night Mode On : Enter the start time when the backlight lights up.
• Night Mode Off : Enter the end time when the backlight lights off.
(Example) When lighting up from 7:00 pm to 6:00 am
Night Mode On : 19
Night Mode Off : 6
* When you do not want to turn on the backlight throughout the day,
set the same value for both “Night-time setting ON” and “Night-time
setting OFF”.
Tire circumfer-
ence
This setting is required if you have paired an ANT+ sensor
capable of speed measurement.
Assign the tire circumference for the sensor capable of speed mea-
surement. (Setting range: 0100 to 3999 mm)
• ISC1 (ISC-1) : Speed/cadence sensor 1
• SPD1 (SP-1) : Speed sensor 1
• ISC2 (ISC-2) : Speed/cadence sensor 2
• SPD2 (SP-2) : Speed sensor 2
* As default, it is set to 2096.
* For the sensor without pairing, the tire circumference cannot be set
even if it is entered.
* ISC2 and SPD2 are used when a computer is commonly used for
two bicycles.
For details, see “Pairing the sensor” (page 36).
* Enter the tire circumference for power sensors capable of transmit-
ting a speed signal in SP-2.
Total distance
You can enter the start value of the total distance, and add the trip
distance to it.
(Setting range: 00000 to 99999)
* This can be used when you renew and/or reset the computer.
* Enter the total distance in integer number only.
Delete the data recorded
in the computer.
Read the current settings
of the computer.