Operation Manual

44
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
Others
How to install the speed/cadence sensor (ISC-11)
1
Temporarily secure the speed sensor
1
Loosen the sensor screw on the speed sensor using a
Phillips screwdriver to check that the sensor arm moves.
Do not completely remove the sensor screw.
2
Att ach the sensor rubber pad to the speed sensor, locate
the speed sensor on the left chain stay as shown in the
figure above, and temporarily secure it with the nylon ties.
Caution: Do not tighten the nylon ties completely
at this stage. Once a nylon tie is tight-
ened, it cannot be pulled out.
Click the button, then a browser will open and a
video will be played back.
Watch video
(YouTube)
Standard accessories
Optional accessories
Optional accessories
1600280N
Bracket band
1602194
Bracket kit
1603790
Cradle (IF-CC01)
1603750
Speed sensor (speed/cadence)
(ISC-11)
1604100
Out-front bracket
1602193
Bracket
1603760
Heart rate sensor
(HR-11)
1602980
Nylon tie bracket
Speed sensor
CADENCE side
Sensor rubber pad
Sensor arm
SPEED side
Sensor
screw
Cadence magnet
Wheel magnet
Speed sensor
Nylon ties
1603595
HR Strap