Owner manual

CC-MC100W MICRO Wireless

ENG

Component name

1 Bracket

2 Speed Sensor A

3 Magnet

4 Bracket Rubber Pad

5 Sensor Rubber Pad

6 Nylon Ties (L x2)

7 Nylon Ties (S x2)

8 Double-sided tape

MICRO Wireless

CYCLOCOMPUTER

CC - MC100W

Owner’s Manual

U.S. Pat. Nos. 4633216/4636769/4642606/5236759 and Design Pat. Pending

CCMC1W-050610 066600370 3

SENSOR

ZONE

SENSOR

ZONE

5 mm

SENSOR ZONESENSOR ZONE

Max.

Distance

70 cm

Max.

Distance

70 cm

PAGE 1
ENG ® MICRO Wireless 1 CYCLOCOMPUTER CC - MC100W Owner’s Manual U.S. Pat. Nos. 4633216/4636769/4642606/5236759 and Design Pat. Pending Copyright© 2005 CATEYE Co., Ltd. 1 2 70 cm 5 7 4 8 1 3 2 Component name 6 3 Max.
PAGE 2
BEFORE USE a Tm Dst Av Mx Odo PUSH! SET : km/h 0 Tm 2 Dst 2 Av 2 AC 2. Select km/h or mph SET D B E C F H G START/STOP MENU I AC ENG J MODE MODE MENU START km/h 3. Wheel Circumference ETRTO 35 6 (59) 26 x 1(65) 26 x 1.25 26 x 1-1/8 37-590 26 x 1-3/8 26 x 1-1/2 26 x 1 - 3/8 L mm 9 3 1952 1953 1970 2068 2100 SET : L = 2068 (mm) (0100 - 3999 mm) SETTING END MODE MODE MODE START/STOP 2097 2098 MENU 2068 Tire size Tire size TIRE START 2096 A Tire size L (mm) 12 x 1.
PAGE 3
Wireless Sensor The sensor was designed to receive signals within a limited range to prevent sensor signal interference. Thus, the sensor and computer must be relatively close. If the temperature or battery power is low, they may need to be even closer than normal. The sensor must be installed at the top of the fork, and the distance between the sensor and the computer should not exceed approximately 70 cm. Install the computer on the stem, with its bottom surface facing the sensor.