User Manual

ENG-13

ENG

* This unit enters the search mode for 5 minutes after starting the ID check.

Press the SSE button during the search mode, then “ID-SKIP” is indicated and it

proceeds to “Selecting speed unit” screen below. Or, unless a sensor signal is

received in 5 minutes, “ID-ERROR” is indicated and it proceeds to “Selecting

speed unit” screen below.

When “ID-SKIP” or “ID-ERROR” is indicated, this unit is not ready for

measurement because the sensor ID has not been registered even though the

set-up is completed. Be sure to check the sensor ID from the menu screen

“Searching the sensor ID” (page 28).

4. Set the sensor ID

Set the speed/cadence sensor ID.

* This unit requres the sensor ID in order for the computer to receive signal from

the sensors.

* To set the sensor ID , be within 5 m from the bicycle with a speed/cadence sensor

mounted properly (page 7).

* When performing ID Synch, make sure there is no other similar sensors in the

surrounding area. (It may pick up other sensor's ID)

1. Verify that the speed/cadence sensor is mounted properly to

the bicycle.

2. Press the SSE button to start searching the speed sensor ID.

When the speed (cadence) is displayed as “ID-OK” on the

screen by spinning the rear wheel or crank, searching is

completed.

Start searching:

SSE

3. Press the MENU button to proceed to “Selecting speed unit”

below.

To “Selecting speed unit”:

(Back)

Continue