User Manual

ENG-14

5. Selecting speed unit

Select the speed unit from “km” and “mile”.

1. Select the speed unit.

C mile:

M1/+

M2/-

2. After selecting, press the MENU button. The measurement

screen appears and the computer set-up is completed.

6. Operation test

Test the functioning of the speed sensor (SPEED) and the cadence sensor (CADENCE).

* If the sensor signal icons,

, and are turned off, press the M1/+ or M2/- button

to turn them on.

Speed sensor (SPEED)

1. Raise the rear wheel and spin the wheel.

2. When

flashes on the computer screen and

the speed is displayed, it is operating normally.

Cadence sensor (CADENCE)

1. Turn the crank.

2. When

flashes on the computer screen

and the cadence is displayed, it is

operating normally.

* When or does not flash, the position of the sensor and the magnet is not

proper. Check and adjust the position of the sensor and magnet again (page 7).

Important:

In the following situations, it is possible that other sensor's ID was picked up;

(such can happen when performing ID Synch at the race venue or group rides)

• Does not display values, even though sensor/magnet position is proper

Recommended Action: Go to the computer's ID Synch setup screen

(page 23) and go through the process of ID Synch. (Make sure that here

is no similar devices in the vicinity. Signal transition distance can vary

from environmental conditions such as weather, buildings, etc)

(or)

Sensor signal status

If there is no incoming signal for approximately 5 minutes, the transmission stops

and no longer receive the sensor data. Once you press the M1/+ or M2/- button, the

computer will come out of the Sleep mode and return to the Stand-by for sensor

signal. Signal transmission status can be checked with Signal icon.

(flashing) : Receiving sensor signal (constant) : Stand-by for sensor signal

(off) : Transmission off