User Manual

ENG-16
SSE
M1/+
SSE
M2/-
LT
SSE
Starting/Stopping the measurement
Initially, the unit starts or stops measurement automatically in sync
with the bicycle motion. This is called auto-mode function.
“km/h” or “mph” flashes during measurement.
The total distance, maximum speed, and maximum cadence are up-
dated independently of stating/stopping measurement.
Auto-mode function
When the auto-mode is turned on ( lights up), the unit detects
the wheel spinning, and starts/stops measurement automatically.
When the auto-mode is turned off (
lights off), the unit starts/
stops measurement by using the SSE button.
* For on/off of the auto-mode, see the menu screen “Setting the auto-
mode” (page 31).
* When the transmission is stopped and Sensor signal icons
,
are off (page 14), the main timer may not start due to speed signal
not responding.
Press the M1/+ or M2/- button to turn on the sensor signal icons
, .
Backlight
Pressing the LT button illuminates the displays for about 3 seconds.
* Pressing any button while backlight is still on extends the illumination
for another 3 seconds.
Resetting the measurement data
To reset the measurement data (TM, DST, Lap Time, C.D. DST, etc)
and the lap data, simultaneously press the SSE button and the
M1/+ or M2/- button in the measurement screen.
* Resetting the measurement data saves the data automatically on a
file. (page 23)
* The screen will freeze for about 2 seconds after resetting; however,
all measurements are operating normally, including the elapsed time.
* The countdown setting (C.D.DSTA) is returned to the manu set
value you set.
* Cannot reset for 5 seconds after pressing the LAP button.
Power-saving function
When the computer does not receive any data for 5 minutes, it will
enter the power-saving mode, in which only the date/clock is displayed.
By pressing any buttons except the AC recovers from the power-
saving mode, and the measurement screen appears. You must press
a button when the computer is in power saving mode before it will
start to measure any data.
Power-saving mode
AT icon
(or)
(Simulta-
neously press)
(Simulta-
neously press)