Manualshelf

Specifications

ManualsBrandsCathode Lighting Systems ManualsPower StripFCLS-Slim
11121314151617181920
LCY-07084A-15
(10) Mechanical characteristics
10-1) External appearance
Do not exist extreme defects. (See Fig. 1)
10-2) Panel toughness
The panel should not be broken, when press to the center of the panel by 19N power using smooth
surface with 15mm diameter.
Caution: If the pressure is added on the active area of the panel over the long time, even if the
pressure is very small weight , the functional damage might occur in the panel.
10-3) I/O connector performance
A) Input/output connectors to control the LCD module
1) Applicable Connector : FH28−60S−0.5SH (HIROSE)
2) FPC flexibility : Slit on the film cover lay coat part of one side printing.
If it had been tested bending under radius nothingness and bending
angle 180degrees, the FPC should not be cut. (It should be bend by
hand and only at once.)
The film cover lay coat part of one side printing.
Do not disconnect by 30 times or less after examining the winding on
the following conditions.
condition : winding radius 0.6mmR and condition of 90° in winding angle
B) I/O connector of backlight driving circuit
1) Corresponding connector : CFP1508-0101F (SMK)
2) FPC flexibility : The same as A) Input/output connectors to control the LCD module
(11) Display quality
The display quality of the color TFT-LCD module is applied to the Incoming Inspection Standard.
(12) Handling instruction of TFT-LCD module
12-1) Handling of FPC
①Please bend FPC only at the film cover lay slit part of one side printing or the film cover lay coat
part of one side printing.
②Please do not hang a LCD module or do not apply excessive power for FPC.
12-2) Installation of TFT-LCD module
①When incorporating the TFT-LCD module, be sure to fix the module on the same plane, and be
careful not to add the stress of wraps or twists to the module.
Do not add the pressure to the module by force of pushing parts on the set side (touch-switches
,etc.)directly, otherwise display images may be disordered.
②Attachment of input/output FPC and removal should surely turn off the power supply of a set.