Specifications

LCY-07084A-17
③When metal part of the TFT-LCD module (shielding case) soiled, wipe it with soft dry cloth.
For stubborn dirt, wipe the part after breathing on there. For water drops or finger grease, wipe
off immediately. Long contact with water may cause discoloration or spots.
④TFT-LCD module uses glass which breaks or cracks easily if dropped or bumped on hard surface.
Handle with care. The LCD used in the module is made of glass. If drop the module or bump it on
hard surface, the LCD should be broken.
⑤Since CMOS LSI is used in this module, take care of static electricity and earth your body when
handling the module.
12-4） Caution of product design
①Protect the LCD module from water/salt-water by the waterproof cover, etc.
②Take measures against electromagnetic shield so that interferential radiation from the module
should not affect peripheral appliances.
12-5） Other
①Do not expose the module to direct sunlight or intensive ultraviolet rays for many hours. Liquid
crystal is deteriorated by ultraviolet rays.
②Store the module at a temperature near the room temperature. At lower than the rated storage
temperature, liquid crystal solidifies, causing the panel to be damaged. At higher than the rated
storage temperature, liquid crystal turns into isotropic liquid and may not recover.
③If LCD panel breaks, there may be a possibility that the liquid crystal escapes from the panel.
Since the liquid crystal is injurious, do not put it into the eyes or mouth. When liquid crystal
sticks to hands, feet or clothes, wash it out immediately with soap.
④Be sure to adjust DC bias voltage of common electrode driving signal(COM DC) in the state
of the last product. When not adjusted, it becomes the cause of a deterioration of display quality.
⑤Observe all precautionary requirements of general electronic components.