Instructions / Assembly

Begin assembly by laying out all of the pieces and checking against the parts list

on the previous pages.Tap Caster sleeves for the caster wheels into the bottom of

the legs using a standard hammer. Do not insert wheels yet. Assemble the Back

Assembly by laying out the Back Right and Left Legs, Back Top Bracel, Back

Center Brace, Back Bottom Brace, Back Vertical Brace and the Back Bottom

Panels as well as the necessary Bastions and 3/4” Steel Pins as shown in

Illustration 1A. Note: Back Center and Back Bottom Braces are slotted whereas

the Front Center and Front Bottom Braces are not.

Tap the 3/4” Steel Pins into place on the Back Vertical Brace and attach to the

Back Center and Back Bottom Braces. Slide one of the Back Bottom Panels into

place, and attach the leg to the Back Center and Bottom Braces using the

Bastions and 3/4” Steel Pins.

Next, attach the Back Top Brace to the leg using the Bastions.

Repeat the procedure to attach the other leg to compete Back Assembly.

Finally, tap the 1” steel pin into the center pilot hole on the Back Center Brace.

This will be used later to support the middle shelf.

BACK ASSEMBLY

Back Right Leg

Back Top Brace

Back Center Brace

Back Bottom Brace

Back

Vertical

Brace

Back Bottom Panel

Back Left Leg

This hole not used in assembly

Caster Sleeve

Illustration 1A