Instructions / Assembly

STEP 2
A. Lay back panel at on a smooth surface with holes up.
B. Decide at this point if you want the handle/towel
bar on the right or the left side of the cabinet as
side panels are interchangeable. We placed the handle/towel
bar on the right for these instructions.
C. Attach side panels with 1 3/4” bolts and hex nuts. After
inserting bolt(s) through the holes in the side panels and through
the holes in the long edges of the back panel, place a hex nut on
the tip of your nger, align nut with bolt and tighten.
D. Look ahead to step 3 which shows side panels attached to
back panel.
NOTE: Back panel is ush with bottom of
side panels.
1 3/4” Phillips Flat Head Bolt (8)
4 Used
in this step
10-24 Hex Nut (8)
4 Used
in this step
4 Used in this step
1” Long 3/16” DIA. Steel Pin
PIN
PIN
5/8” Phillips Head #7 Screw
4 Used in this step
STEP 3
A. Turn the side/back assembly
(from step 2) upside down (invert)
on top of the inverted table top.
B. Align the “L” brackets
with the 4 pilot holes in the table top
and secure with 5/8” #7 screws.
C. Tap two 1” pins into each side
panel. These pins will hold the
bottom shelf. See illustration 3.
ILLUSTRATION 3
Side Panel Leg
Inside Brace
Countersunk Hole in Leg
( disk goes in this hole to
hide bolt head! )
Nut Access Hole
Hex Nut
ILLUSTRATION 2