Instructions / Assembly

STEP 5
Take the 2 front braces and tap/insert one 3/4”
steel pin into each end of both braces until seated.
About 3/8” will stick out when seated. Ok if loose.
4 used in this step
3/4” Long 3/16” DIA. Steel Pin
STEP 6
A. Take the top front brace (with
magnet block), insert the pins in
the brace ends into the slots of
the inside of the front legs and
slide down until the holes in the
brace ends align with the holes
in the front legs as in illustration
6A. The pin holes for the door
pins will be up as will the magnet
block.
B. Secure brace with 1 3/4” bolts
and hex nuts.
1 1/4” #8 Bolts
Insert Brace Pins Here
Glide Suport
Assembly
2 used in
this step
1 3/4” Phillips Flat Head Bolt
2 used
in this step
10-24 Hex Nut
ILLUSTRATION 6