Instructions / Assembly

1 3/4” Phillips Flat Head Bolt
2 Used in this step
10-24 Hex Nut
2 Used
in this step
2 Used
in this step
3/16” Flat Washer
STEP 9
A. Install doors by inserting pins in the
door tops into the holes in the long
edge top front brace.
B. Place one washer on each pin in
the door bottoms.
C. Take the bottom front brace, align
pins in door bottoms with holes along
top long edge of brace (are washers
on pins?) and secure brace with 1 3/4”
bolt/hex nuts as before.
1 3/4” Phillips Flat Head Bolt
2 Used in this step
10-24 Hex Nut
2 Used
in this step
2 Used
in this step
3/16” Flat Washer
STEP 10
A. Stick magnet to magnet plate on right door.
B. With left door open, close the right door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the right
door. The magnet will be in the correct position on the block.
C. Secure magnet with the two pan head screws in the magnet packet. Center screws in the slots in
the magnet. This will allow adjustment later, if needed.
NOTE: No pilot holes in block as softwood!
Magnet
5/8” Pan Head Screw
2 Used
in this step
ILLUSTRATION 10