User's Manual

Remtron

Engineered Systems

User Manual

9M02-9028-A021-EN

Version 4.0

Belly Box Transmitters

1. Open the battery compartment door on the transmitter.

2. Remove and replace the AA Alkaline batteries. Be sure to observe the correct polarity.

3. Close the door and tighten the thumb screw.

7.3.4 Changing the Transmitter ID Code

Changing the ID Code requires use of a Cattron RAC16 Series programmer. Refer to Figure 16 for the handheld

transmitters.

1. Confirm that the batteries are in good condition (refer to Transmitter Troubleshooting).

2. Remove the screws on the back of the transmitter and remove the back panel from the case. On ‘A’

Series IP67 rated transmitters, remove the battery door and batteries before removing the back of the

transmitter. On the belly box transmitters, open the battery compartment door.

3. Attach the programming plug to the 4-pin connector on the circuit board, or, if using the belly box adapter,

to the mini-DIN connector. Verify that the ID Code is displayed.

4. Enter the new ID Code and press the PRG key. The RAC16 display reads ‘SUCCESS’. Verify new ID

Code by pressing BKSP and ESC keys.

5. Reassemble the transmitter in reverse order, making sure that the battery wires do not get pinched

between the back panel and the case. Tighten the screws snugly. On ‘A’ Series IP67 rated transmitters,

replace the battery door and batteries after replacing the back panel. ‘A’ Series captive screws should be

tightened until snug, plus half a turn.

Refer to the RAC16 Series User Manual for more detailed instructions.