CavVelo DSL Modem Guide 1/13/05 9:31 AM Page c1 CavVelocity CavVelocity DSL Modem with Inline Phone Filter Installation Instructions
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page c2 About Your DSL Service You have just received the Cavalier Telephone DSL Self Installation Kit. After you connect your computer to the DSL modem and install the necessary Ethernet components in your computer, your DSL service will enable you to be connected to the Internet at all times and place calls on the same line.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 1 CavVelocity 6381 DSL Modem with Inline Phone Filter Installation Instructions STEP 1 – Package Checklist Verify that your package contains the following: DSL Modem Power Supply RJ-45 Ethernet Cable RJ-11 Telephone Cable Two Telephone Filters 1
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 2 STEP 2 – Installing the CavVelocity 6381 DSL Modem Place the CavVelocity 6381 DSL Modem on a flat surface with clearance for the rear connectors. 1. Connect the LINE port on the modem to the Phone jack using the supplied phone cable. 2. Connect the PHONE port on the modem to a normal telephone (optional, you may choose not to use phone port). 3.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 3 Steps for Telephone Service Setting up Your PC for DSL Connect a microfilter to each phone jack where you are using a telephone or other device on the same phone line as the DSL modem. DSL filters block the DSL signal from reaching your phone, fax, and other devices. EXCEPT for your DSL modem, every device sharing the phone number that has DSL needs a filter. Unused jacks do not need a filter.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 4 Setup Instructions for Windows XP 1. Click your Start button, Run. In the run bar type NCPA.CPL. Click the OK button 2. A Network Connections window will open (Fig 1.1) ■ Right click on Local Area Connection, left click on Properties 3. The Local Area Connection Properties window will open up (Fig 1.2) ■ Double click on Internet Protocol (TCP/IP) 4. The Internet Protocol (TCP/IP) Properties window will open (Fig 1.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 5 Setup Instructions for Windows 2000 1. Right click on My Network Places, click on Properties (Fig 2.1) ■ Add the primary and secondary DNS numbers below based upon your state • VA & MD: 64.83.0.10 • VA & MD: 64.83.1.10 • PA: 209.137.171.10 • PA: 209.137.171.20 • DE: 209.137.160.7 • DE: 209.137.160.3 2. A Network and Dial-Up Connections window will open up (Fig 2.2) ■ Right click on Local Area Connection, left click on Properties 3.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 6 Setup Instructions for Windows 98/ME 1. Right click on Network Neighborhood, left click on Properties (Fig 3.1). 2. Click on the Configuration tab (Fig 3.2) ■ Go to TCP/IP for Ethernet card 3. Click on the IP Address tab (Fig 3.3) ■ Click on Specify an IP address ■ Enter the IP Address from your welcome letter in the IP Address field ■ Enter the Subnet Mask of “255.255.255.0” in the Subnet mask field 4. Click on the DNS Configuration tab (Fig 3.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 7 Setup Instructions for Macintosh OS X (10.3) 5. Click on the Gateway Tab (Fig 3.5) ■ Add the Gateway Address provided in your welcome letter 6. Click the OK button Note: Screenshots may be different, depending on your version of the OS X operating system.) 1. Click on the Apple Menu in the top, left corner of your screen and select System Preferences. (Fig 4.1) 7. Click OK at the Network window 2. Click on Network (Fig 4.2) 8.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page 8 ■ Enter 255.255.255.0 in the Subnet Mask field ■ Enter your default gateway To check to see if you are connected to our network: ■ Go to Start, Run, type in “command” and ping your DNS Server IP (ie. “ping 64.83.0.10”) The DNS Server IP is provided in your welcome packet. ■ If you get a reply back you are ready to “ping” someone else. Try yahoo.com by typing in “ping yahoo.com.” If you get a reply back from yahoo.com you are in service.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page c3 If you’ve followed the instructions and it’s still not working, please try the following steps: IF none of the lights are lit: 1. Make sure that you are using the power supply provided with the modem. 2. Try plugging into another wall outlet (one that is known to be functioning). IF the “Line” light is not lit: 1. Make sure that you’re using the telephone cable provided with the modem.
CavVelo DSL Modem Guide 1/13/05 9:31 AM Page c4 C ISP Technical Help Desk – 877-459-9182
