Installation Guide
Page 15
Specications
*
:
Body Stainless Steel / Tempered Glass
Power Rating 220V/50Hz or 120V/60Hz (USA & Canada standard)
General Input Power 358 W (218W + 4x35W)
Motor Input Power 218 W
Motor Revolution 600 RPM (±10%) to 1800 RPM (±10%)
Levels Of Speed Control 6 Levels
Maximum Airow 900 CFM
Air Pressure 320 pa
Noise Level (dB / sone) Approximately 23 / 0.3 to 68 / 7.0 (Lowest to highest Speed)
Motor Type Dual Chamber Ultra Quiet
Fan Type Dual Centrifugal / Sirocco
Control Type Dual Electronic Control Panels with LCD Display
Filtration Type Aluminum Filter with Reversible Handle
Illumination 35W Maximum, Dimmable
Venting Size Top, 6 inches Round
Interference Protection Radio Frequency Interference Protected
* Subject to change without notice, please contact your local reseller for details.
Use and Care Information
Operations:
Read and understand all instructions and warnings in this manual before operating the appliance. Save these •
instructions for future reference.
Always leave safety grills and lters in place. Without these components, operating blowers could catch on to •
hair, ngers and loose clothing.
NEVER dispose cigarette ashes, ignitable substances, or any foreign objects into blowers.•
NEVER leave cooking unattended. When frying, oil in the pan can easily overheat and catch re. The risk of •
self combustion is higher when the oil has been used several times.
NEVER cook on “open” ames under the range hood. Check deep-fryers during use: Superheated oil may be •
ammable.
Cleaning:
The saturation of greasy residue in the blower and lters may cause increased inammability. Keep unit clean •
and free of grease and residue build-up at all times to prevent possible res.
Filters must be cleaned periodically and free from accumulation of cooking residue (see cleaning instructions •
on Page 17). Old and worn lters must be replaced immediately.
DO NOT operate blowers when lters are removed. Never disassemble parts to clean without proper instruc-•
tions. Disassembly is recommended to be performed by qualied personnel only. Read and understand all
instructions and warnings in this manual before proceeding.
Specications