Use and Care Manual
Page 12
Range Hood Operations
Control Panel Layout and Buttons Congurations:
This range hood is equipped with remote control and heat sensor that will self-calibrate within 5 seconds when the
range hood is rst electrically activated. Self-calibration will be set when the range hood beeps. LCD panel will
turn off automatically after a period of inactivity.
Adjusting Heat Sensor Auto Function Temperature:
• Press Auto Function button to enter the heat sensor auto function temperature setting mode. User
dened temperature and “Auto Function” icon will appear and ash in LCD panel. Press Increase or Decrease
button to adjust to desired temperature from 34C to 48C. Press Auto Function button again to exit the heat sen-
sor auto function temperature setting mode.
• While the blower (motor) is running, the heat sensor evaluates surrounding temperature and increase
the blower to the top speed automatically when reached the user dened temperature. The blower speed de-
creases by 1 level in every 20 seconds when the surrounding temperature is below the user dened temperature
and back to the original speed level.
Activating Normal Blower Function:
• While the range hood is off, press Increase or Decrease button to start the blower. Press Increase button
to increase blower speed (F1 to F4) as indicated in LCD panel. The Increase button cycles blower settings from
off (00), quiet speed (F1), low speed (F2), medium speed (F3) to high speed (F4).
• While the range hood is on and the blower is running, press Decrease button to decrease blower speed
(F4 to F1) as indicated in LCD panel. The Decrease button cycle blower settings from high speed (F4), to medium
speed (F3), low speed (F2), quiet speed (F1) to off (00).
Remote Control
Sensor
Power-Off
Delay
Light
LCD Panel
Decrease
Increase
Auto Function