Installation Guide
Page 11
Installation (Continued)
Connect the range hood to a designated standard outlet (please 7.
refer the product label for the suitable voltage of this unit)
or cut off the plug and connect three wires (black, white and
green) to house wires and cap with wire connectors. Connect
according to colors (i.e. black to black, white to white, and
green to green).
Store excess wires in the wiring box.8.
Install both chimneys and tighten screws to secure the lower chimney to the range hood as shown in Figure 9.
5.
To avoid scratching the chimney, extend the upper chimney slowly and carefully to the chimney-mounting 10.
bracket and tigten screws as shown in Figure 6.
To install stainless steel bafe lters, refer to Figure 7 for the following ve steps:11.
Angle bafe lter toward back of hood.
Push bafe lter up until almost level.
Slide forward into recess behind the front of hood.
Lower bafe lter.
Slide back until it ts into resting positions.
Repeat Step 12 to install all stainless steel bafe lters.12.
Turn powe ON in control panel. Check all lights and fan operations.13.
Make sure to leave this Installation Guide for the homeowner.14.
Figure 8
Figure 7
Figure 6