Installation

Pg 13
Control Panel, Display and Functions:
Range Hood Operations
In addition to the remote control feature, this range hood is also equipped with a heat
sensor that will self-calibrate in 5 seconds when the range hood is first electrically
activated and beeps when self-calibration is done. To con- serve energy, the LCD panel
will turn off automatically after 5 seconds of inactivity. For the best results, start the
range hood before cooking and allow it to operate several minutes after the cooking is
completed to clear all smoke and odors from the kitchen.
Adjusting Heat Sensitive Auto Speed (HSAS) Function:
Activating Ventilation Function:
While the range hood is off, use the Increase or Decrease buttons to start the blower.
Press Increase button to increase blower speed (“F1” to “F4”) as indicated in LCD panel.
The Increase button cycles blower settings from “off” (00), “quiet” speed (F1), “low”
speed (F2), “medium” speed (F3) to “high” speed (F4).
While the range hood is on and the blower is running, press Decrease button to decrease
blower speed (“F4” to “F1”) as indicated in LCD panel. The Decrease button cycle blower
settings from “high” speed (F4), to “medium” speed (F3), “low” speed (F2), “quiet” speed
(F1) to “off” (00).
Press the Auto Function button to turn On/Off the Auto Mode. The Auto Function Icon
will illuminate in the LCD Panel when Auto Mode is On.
While the range hood is off, press and hold Auto Function button to enter the
temperature setting mode. Use the Increase or Decrease button to adjust the comparison
temperature value between the internal and external heat sensors from “8°” to
“20°” (these values are not exact measurements but are level settings). The temperature
setting mode will exit automatically after 5 seconds of inactivity.
While the range hood is off and Auto Function is activated, the blower will turn on to its
highest speed automatically when the internal temperature is 4 times above the external
temperature. It will then adjust the speed level (between F4 to F1) automatically
according to the detected temperature between the sensors (4 times to 1 time). The
automatic speed level can be manually overwritten by pressing the Increase or Decrease
button and then Auto Function will reactivate after 2 minutes. The blower can ONLY be
turned off MANUALLY or by activating the Power-Off Delay Timer Function.
•
•
•
•
•