Installation Guide & User Manual
Page 13
Range Hood Operations (Continued)
Control Panel Layout and Buttons Congurations:
Activating Light Function:
• Press Light button once to turn on the lights, and once again to turn off the lights.
• While the lights are off, press and hold Light button for over 3 seconds to dim the lights from high to
low. Level of brightness will be stored in system’s memory.
CAUTION: DO NOT touch the lights until switched OFF and cooled.
Activating Power-Off Delay Function:
• While the range hood is on and the blower is running in normal mode, press Power-Off Delay button
to activate delay off timer. Adjust to desired period of delay off timer by pressing Increase or Decrease button
(minimum 1 minute to maximum 15 minutes). Timer beings to countdown immediately, when it reaches 0, the
blower will shut off.
Remote Control Sensor:
• Remote control sensor receives infrared (IR) signal from the remote control. The maximum distance
for IR data transmission is 3 meter and requires direct line of sight. The transmission distance may vary depend-
ing on temperature and remote control battery condition.
Remote Control
Sensor
Power-Off
Delay
Light
LCD Panel
Decrease
Increase
Auto Function
Note: Light settings are independent from other settings (including power-off delay) and lights have to be
manually turned on or off.
Note: The system saves user congurations, settings such as light, timer and blower (motor) speed will re-
main the same the next time it is turned on.