Installation

anchors – DO NOT fasten screws all the
way down; leave approximately 3/32” of
gap from the wall to the screw head. Hang
the range hood body onto the Type “B
”
screws. Ensure the range hood is level and
then fasten the screws completely.
Note: for wall mounted range hoods (not
island mounted), the rear panel of the
range hood body (against the installation
wall) is plain sheet metal and can be drilled
and screwed into the wall for additional
stabilization. DO NOT drill into or screw
through any wires, any wire harnesses, or
any critical fixtures.
Install the upper chimney mounting
bracket (if using factory hardware):
Reference steps "4" & "5" to complete this
step "6", at the locations previously marked
in step "3".
Install the flexible duct tube:
First install the flexible duct tube onto
your household ducting and then extend
the ducting downward, allowing about 6
inches of extra ducting; cut off excess
ducting.
Install the ducting onto the range hood
(body) duct adaptor. Use certified ducting
tape or fastening devices.
Install power plug:
Plug in the power cord into your power
socket. DO NOT turn on main power
supply until installation is complete; or if a
function test is desired (should be done
before starting installation); clear
workspace; ensure workspace is safe, and
then temporarily supply power to unit and
then test functions. Please ensure to
completely SHUT OFF POWER SUPPLY
after testing and before continuing
installation.
Pg 12
Installation (Continued)
Hold in position and
secure lower chimney
to range hood
Fasten mounting
bracket
Slide up and secure
upper chimney to
mounting bracket
Figure 5
Figure 4A
BACK SUPPORT
DRYWALL
6.
7.
8.