WALL MOUNT RANGE HOOD Installation Manual IMPORTANT NOTICE: Read and save these instructions. Installer: Leave this guide with the homeowner. Homeowner: Keep this guide for future reference.
Table of Contents INSTALLATION Safety Notice .............................................................................................................................................................1-2 Specifications ................................................................................................................................................................ 3 Parts Supplied .................................................................................................................
Important Safety Notice • Ducted fans MUST always be vented to the outdoors. • DO NOT vent exhaust into spaces between walls, crawl spaces, ceiling, attics or garages. • Any old duct work should be cleaned or replaced if necessary to avoid the possibility of a grease fire. Check all joints on duct work to insure proper connection and all joints should be properly taped. • Use only metal ductwork and this unit MUST be grounded.
Specifications Body Material Stainless Steel, Brushed Finish Overall Voltage 115V/60Hz Maximum Power Usage 88W Lighting Wattage l.5W(x2) Lamp Type LED Motor Power 85W Motor Speed 1388 to 2237 RPM , 3 Levels Motor Type Induction, Ultra Quiet Fan Type Centrifugal Maximum Airflow 400 CFM Air Pressure 128 pa Noise Level (dB/ Sone) 44.25 to 56.
Preparation Advanced Preparations: 1. Familiarize yourself with the controls of the range hood by reading through Range Hood Operations, Page 15. Excessive Weight 2. Place the range hood on a flat, stable surface. Connect the Require three or more persons to range hood to a designated standard outlet (please refer move and install this range hood. the product label for the suitable voltage of this unit) and Spinal or other bodily injuries turn on the range hood.
Installation Overview ® --� i ® Qty: 9 PCS �@ ---+----- Upper Chimney @ Qty: 2 PCS ® ---+----- Lower Chimney �© Qty: 9 PCS ------- 6" Round Duct (Exhaust) ------- Motor Housing Note: Type "A" anchors are designed for for dry wall or sheet rock. Not to be used with any other types of walls. Wall Mount Range Hood Installation 1. Confirm where you want your range hood installed Confirm your centerline and side measurements of each piece of hardware.
Troubleshooting If the range hood or light does not operate after installation: • Check if the range hood has been plugged in, make sure that all power has been turned back ON, and all electrical wiring are properly connected. Swap out light bulb to working ones to determine • whether it is caused by defective bulbs. See Replacing the light bulbs on Page 20. The range hood vibrates when the suction is on: • The range hood might not have been secured properly on to the ceiling or wall.
Electric Schematic Black -- -- L E N l Green White 7 _J -- L M H Motor Lamp Touch Switch PCB * Subject to change without notice, please contact your local reseller for details.