Installation

Pg 14
CAUTION: DO NOT touch the lights until switched OFF and cooled.
Note: Light settings are independent from other settings (including power-off delay) and lights has to be
manually turned on or off.
Note: The system saves user configurations, settings such as light, timer and vent (motor) speed will
remain the same the next time it is turned on.
Adjusting the hood (motor) speed:
• Press Power button once to turn on the system. The Vent Function Indicator icon
flashes showing that the suction is ready. Decrease button will decrease the speed of the
vent from 6 to 1 (strongest to quietest). Increase button will increase the speed of the
vent from 1 to 6 (quietest to strongest).
• Press Power button once to turn off the system.
Note: The system saves user configurations, settings such as light, timer and blower (motor) speed will
remain the same the next time it is turned on.
Adjusting the timer function:
• While the vent (motor) is not running, press and hold Decrease button over 3 seconds
to enter timer mode. Adjust to desired period of delay off timer by pressing Increase
or Decrease button (minimum 1 minute to maximum 15 minutes).
This setting will be saved immediately.
Activating the timer function:
• While the vent (motor) is running, press and hold Power button for over 3 seconds to
activate Delayed Power-Off Timer. Delayed Power-Off Indicator will illuminate and
Delayed Power-Off Timer will begin to countdown, when it reaches zero, the vent
will shut down.
Adjusting the light:
• Press Light button once to turn on the lights, and once again to turn off the lights.
• While the lights are off, press and hold Light button for over 3 seconds to dim the lights
from low to high. Level of brightness will be stored in system’s memory.
Range Hood Operations (Continued)
Controls:
Automatic cleaning reminder:
• This range hood is equipped with a cleaning reminder that will activate following 30 hours
of use. When the hood (motor) starts, cumulative running time will be shown in Vent
Elapse Timer. This timer icon flashes when 30 hours is up and reminds user to clean the
aluminum filter.
• After cleaning the filter and when the hood is not in use, press and hold Increase button
over 3 seconds to reset the Vent Elapse Timer. Please note that turning off the system will
not reset the timer.
Adjusting the hood (motor) speed:
• Press Power button once to turn on the system. The Vent Function Indicator icon
flashes showing that the suction is ready. Decrease button will decrease the speed of the
vent from 6 to 1 (strongest to quietest). Increase button will increase the speed of the
vent from 1 to 6 (quietest to strongest).
• Press Power button once to turn off the system.
Note: The system saves user configurations, settings such as light, timer and blower (motor) speed will
remain the same the next time it is turned on.
Adjusting the timer function:
• While the vent (motor) is not running, press and hold Decrease button over 3 seconds
to enter timer mode. Adjust to desired period of delay off timer by pressing Increase
or Decrease button (minimum 1 minute to maximum 15 minutes).
This setting will be saved immediately.
Activating the timer function:
• While the vent (motor) is running, press and hold Power button for over 3 seconds to
activate Delayed Power-Off Timer. Delayed Power-Off Indicator will illuminate and
Delayed Power-Off Timer will begin to countdown, when it reaches zero, the vent
will shut down.
Adjusting the light:
• Press Light button once to turn on the lights, and once again to turn off the lights.
• While the lights are off, press and hold Light button for over 3 seconds to dim the lights
from low to high. Level of brightness will be stored in system’s memory.