Installation Sheet

6
PAGE
Single
Note: Single Soft Close requires one front activator only.
Twin Soft Open & Close requires two activators. One should already be in the track above the pocket (Page 4).
Single & Twin
Set rear activator position.
Close the door and move the rear activator into the approximate centre
of the pocket.
Do not tighten grub screws.
Position the activator setting block inside the back stud and gently open
the door onto it.
The activator will slide along the track into the correct position.
The rear activator is now positioned. Securely tighten all four grub
screws.
Twin ONLY
CLICK!
Hold red activator setting block on
closing jamb/finished wall & gently
close door. Activator will slide to
correct position.
Securely tighten grub screws.
Gently close door until activator
clicks. The cassette is now charged.
Open door & loosen activator grub
screw.
Slide activator to centre of door
opening and tighten one grub
screw.
1.
4.
2.
3.
Set front activator position.
6.5.
To lower
door
To raise
door
Adjust track stop position
(if using mount plates with stop)
Adjust door for plumb
and clearance